bassmannate
Dabbler
- Joined
- Nov 24, 2022
- Messages
- 15
I have a new install of TrueNAS scale on a server and all the drives besides the boot pool are showing 0B capacity.
I've been using Linux for a long time now but I'm very new to both TrueNAS as well as ZFS so I'm a little lost on where to begin. I'm waiting on one more cable to get the rest of my drives online but I figured I would boot it up to make sure that everything is recognized. It sees all the drives I have currently connected but it shows 0B capacity on all 4 drives. These are 3TB SAS drives connected through a Dell H200 flashed for IT mode.
I've done a bit of searching without much luck. I've tried wiping through the web interface both quick and with 0s. Maybe I should try through the shell with dd? All tests seem to indicate that everything is good. I've checked smartctl and it looks like the drives are on and spinning and that everything looks good.
Again, I've never used ZFS or TrueNAS so tell me what ever you need me to post to assist in figuring this out. Thanks in advance!
I've been using Linux for a long time now but I'm very new to both TrueNAS as well as ZFS so I'm a little lost on where to begin. I'm waiting on one more cable to get the rest of my drives online but I figured I would boot it up to make sure that everything is recognized. It sees all the drives I have currently connected but it shows 0B capacity on all 4 drives. These are 3TB SAS drives connected through a Dell H200 flashed for IT mode.
I've done a bit of searching without much luck. I've tried wiping through the web interface both quick and with 0s. Maybe I should try through the shell with dd? All tests seem to indicate that everything is good. I've checked smartctl and it looks like the drives are on and spinning and that everything looks good.
Again, I've never used ZFS or TrueNAS so tell me what ever you need me to post to assist in figuring this out. Thanks in advance!
Last edited: