FreeNAS 11U4 shows up as 11U2 in my system

[NasKar]

I installed an SSD as my boot drive and changed the BIOS setting to get it to boot from it instead of my USB stick. After a fresh install of FN11U4 on my SSD I rebooted and the system info says I have FN11U2. The USB stick had U3 on it. Thinking I made an error in my download I recreated the USB install of U4 after a fresh download of it. After my reinstall and reboot again it says U2. I upgrade the U2 to U4 from the GUI and rebooted and again it says i'm using FN11U2. I'm completely confused. Any idea on what's happening?

 

[nightshade00013]

One of two things, it's either not completing (USB sticks take a LONG time so start the update and leave it alone for a few hours), or it's not switching like it should in which case click on the system tab and the boot sub-tab and make sure the environment says "On Reboot" for the version you are wanting to use, then reboot and it should be the right one. Every once in a while it will act up.

 

[NasKar]

After rebooting and selecting the SSD ada0 from the boot menu it still boots from the USB stick da0. Do I have to remove the USB from the motherboard to boot from the SSD?

 

[NasKar]

It seems like the system booted from the USB drive anyway and used the original install of U2. I removed the USB stick and it booted from the SSD on an
IO Crest SI-PEX40062 4 Port SATA III PCIe 2.0 x2 Controller Card. After uploading the config to the clean install of FN11U4 I noticed errors before it gets to the actual FreeNAS boot menu I think they were HDD errors. Scrolled to fast to get a screen capture of it. Checking the desmsg.today file I found 2 errors.

Code:

pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pcib0: _OSC returned error 0x10
pci0: <ACPI PCI bus> on pcib0
pcib1: <ACPI PCI-PCI bridge> irq 16 at device 1.0 on pci0
pci1: <ACPI PCI bus> on pcib1

and

Code:

WARNING: VIMAGE (virtualized network stack) is a highly experimental feature.
ioapic0 <Version 2.0> irqs 0-23 on motherboard
random: entropy device external interface
kbd1 at kbdmux0
module_register_init: MOD_LOAD (vesa, 0xffffffff80fa9d40, 0) error 19
random: registering fast source Intel Secure Key RNG
random: fast provider: "Intel Secure Key RNG"
nexus0
cryptosoft0: <software crypto> on motherboard