GreyKatana
Dabbler
- Joined
- Oct 3, 2015
- Messages
- 31
Hi guys, finally received my Supermicro X10SLL-F (after receiving a X10SLM+F with a bent serial port), built the whole system tonight, power led is on and heartbeat led is blinking, everything's looking good.
I push the power button... nothing. Not a beep, no fans start spinning, absolutely dead silent.
So I check the front panel connections and everything seems good. I even tried bridging the power button pins (as suggested in the Supermicro manual) and nothing. There's power going to the board otherwise the LED wouldn't light up, but nothing else works.
Do you guys have any ideas? At this point I'm guessing bad mobo. This is my first Supermicro product (well second after the broken X10SLM) and if this board is DOA, this might very well be my last.
Full specs just in case (but since it doesn't turn on I don't think it matters anyway):
Supermicro X10SLL-F
Pentium G3450
8GB Crucial 1600MHz ECC Memory
Seasonic G-360
Fractal Design R4
2 x 1TB WD Red Drive
2 x 32GB Sandisk Ultra Fit Boot Device
And a whole bunch of disappointment
Thanks for the help.
I push the power button... nothing. Not a beep, no fans start spinning, absolutely dead silent.
So I check the front panel connections and everything seems good. I even tried bridging the power button pins (as suggested in the Supermicro manual) and nothing. There's power going to the board otherwise the LED wouldn't light up, but nothing else works.
Do you guys have any ideas? At this point I'm guessing bad mobo. This is my first Supermicro product (well second after the broken X10SLM) and if this board is DOA, this might very well be my last.
Full specs just in case (but since it doesn't turn on I don't think it matters anyway):
Supermicro X10SLL-F
Pentium G3450
8GB Crucial 1600MHz ECC Memory
Seasonic G-360
Fractal Design R4
2 x 1TB WD Red Drive
2 x 32GB Sandisk Ultra Fit Boot Device
And a whole bunch of disappointment
Thanks for the help.