Over the last few weeks I keep getting the following error:
Zpool status tells me that a small amount of data has been resilvered. The size of the data has always been different the three times that this has happened so far (156K, 180K, now 80K):
Everytime this happens I run an extended SMART test to find any problems with the drive, but each time no errors are reported.
Just to make sure I wasn't testing the wrong disk, I went into the FreeNAS Volume Status > Edit Disk to pull the serial number of the problem disk. I confirmed that I was checking the problem disk via this method. When I received the particular disk about four months ago, Newegg shipped it in a bubble wrap HDD sleeve. A few of the bubbles, which are few and span the length of the disk, were completely deflated. I did an extended SMART test and a badblocks -wsv test on the drive when I received it, but no problems were revealed so I didn't send the drive back to Newegg.
All the drives in the NAS are WD40EFRX connected to an IT flashed IBM ServeRAID M1015 via mini-SAS to SATA cables. I am using 32GB ECC RAM in this system. I'd appreciate any help in trying to fix this problem. I've already RMA'd two of the WD40EFRX drives that were in the system, but they had SMART test errors. Since this particular drive keeps passing the SMART tests, I'm afraid of sending it in for an Advanced RMA and getting charged for sending in a good drive.
Thanks in advance for any help.
Code:
> (da4:mps0:0:6:0): WRITE(16). CDB: 8a 00 00 00 00 01 18 48 3f 90 00 00 00 08 00 00 > (da4:mps0:0:6:0): CAM status: SCSI Status Error > (da4:mps0:0:6:0): SCSI status: Check Condition > (da4:mps0:0:6:0): SCSI sense: ILLEGAL REQUEST asc:21,0 (Logical block address out of range) > (da4:mps0:0:6:0): Info: 0x118483f90 > (da4:mps0:0:6:0): Error 22, Unretryable error
Zpool status tells me that a small amount of data has been resilvered. The size of the data has always been different the three times that this has happened so far (156K, 180K, now 80K):
Code:
pool: tank1 state: ONLINE status: One or more devices has experienced an unrecoverable error. An attempt was made to correct the error. Applications are unaffected. action: Determine if the device needs to be replaced, and clear the errors using 'zpool clear' or replace the device with 'zpool replace'. see: http://illumos.org/msg/ZFS-8000-9P scan: resilvered 80K in 0h0m with 0 errors on Sun Feb 16 13:34:37 2014 config: NAME STATE READ WRITE CKSUM tank1 ONLINE 0 0 0 raidz2-0 ONLINE 0 0 0 gptid/6177eafb-4c2c-11e3-a43a-002590d72d3b ONLINE 0 0 0 gptid/91cabea9-8b48-11e3-a7b6-002590d72d3b ONLINE 0 0 0 gptid/634c34ad-4c2c-11e3-a43a-002590d72d3b ONLINE 0 0 0 gptid/64368d6a-4c2c-11e3-a43a-002590d72d3b ONLINE 0 0 0 gptid/6524b559-4c2c-11e3-a43a-002590d72d3b ONLINE 0 0 0 gptid/6a4eecce-75d3-11e3-8a04-002590d72d3b ONLINE 0 1 0 logs gptid/349c2eca-4c2d-11e3-a43a-002590d72d3b ONLINE 0 0 0 errors: No known data errors
Everytime this happens I run an extended SMART test to find any problems with the drive, but each time no errors are reported.
Code:
=== START OF INFORMATION SECTION === Device Model: WDC WD40EFRX-68WT0N0 Serial Number: WD-WCC4E0477430 LU WWN Device Id: 5 0014ee 2b3e0e355 Firmware Version: 80.00A80 User Capacity: 4,000,787,030,016 bytes [4.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ACS-2 (minor revision not indicated) SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Mon Feb 17 06:45:10 2014 EST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: (53760) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 537) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x703d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x002f 200 200 051 Pre-fail Always - 0 3 Spin_Up_Time 0x0027 178 176 021 Pre-fail Always - 8100 4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 24 5 Reallocated_Sector_Ct 0x0033 200 200 140 Pre-fail Always - 0 7 Seek_Error_Rate 0x002e 200 200 000 Old_age Always - 0 9 Power_On_Hours 0x0032 099 099 000 Old_age Always - 1100 10 Spin_Retry_Count 0x0032 100 253 000 Old_age Always - 0 11 Calibration_Retry_Count 0x0032 100 253 000 Old_age Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 24 192 Power-Off_Retract_Count 0x0032 200 200 000 Old_age Always - 21 193 Load_Cycle_Count 0x0032 196 196 000 Old_age Always - 12736 194 Temperature_Celsius 0x0022 122 095 000 Old_age Always - 30 196 Reallocated_Event_Count 0x0032 200 200 000 Old_age Always - 0 197 Current_Pending_Sector 0x0032 200 200 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0030 100 253 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0 200 Multi_Zone_Error_Rate 0x0008 200 200 000 Old_age Offline - 0 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 1093 - # 2 Extended offline Completed without error 00% 1073 - # 3 Extended offline Interrupted (host reset) 10% 1056 - (Note: I rebooted the server before this test finished) # 4 Short offline Completed without error 00% 1045 - # 5 Short offline Completed without error 00% 1021 - # 6 Short offline Completed without error 00% 997 - # 7 Short offline Completed without error 00% 974 - # 8 Short offline Completed without error 00% 950 - # 9 Short offline Completed without error 00% 926 - #10 Short offline Completed without error 00% 902 - #11 Short offline Completed without error 00% 878 - #12 Extended offline Completed without error 00% 867 - #13 Short offline Completed without error 00% 857 - #14 Short offline Completed without error 00% 854 - #15 Short offline Completed without error 00% 830 - #16 Short offline Completed without error 00% 806 - #17 Extended offline Completed without error 00% 794 - #18 Short offline Completed without error 00% 782 - #19 Short offline Completed without error 00% 758 - #20 Short offline Completed without error 00% 734 - #21 Short offline Completed without error 00% 715 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.
Just to make sure I wasn't testing the wrong disk, I went into the FreeNAS Volume Status > Edit Disk to pull the serial number of the problem disk. I confirmed that I was checking the problem disk via this method. When I received the particular disk about four months ago, Newegg shipped it in a bubble wrap HDD sleeve. A few of the bubbles, which are few and span the length of the disk, were completely deflated. I did an extended SMART test and a badblocks -wsv test on the drive when I received it, but no problems were revealed so I didn't send the drive back to Newegg.
All the drives in the NAS are WD40EFRX connected to an IT flashed IBM ServeRAID M1015 via mini-SAS to SATA cables. I am using 32GB ECC RAM in this system. I'd appreciate any help in trying to fix this problem. I've already RMA'd two of the WD40EFRX drives that were in the system, but they had SMART test errors. Since this particular drive keeps passing the SMART tests, I'm afraid of sending it in for an Advanced RMA and getting charged for sending in a good drive.
Thanks in advance for any help.