lexxai
Dabbler
- Joined
- Nov 9, 2016
- Messages
- 33
FreeNAS 11.2-U1
Detect that when on remote system I start use attached iSCSI disk for write
On FreeNAS system have start messaging about error disk (device: ATA error count increased ...)
but cable checked, reattached, and errors on differ disk can be.
If use SAMBA services, NOT HAVE any errors on disk.
S.M.A.R.T. status of all disks is OK.
Disks SATA, WD RED 2TB. Connected to MB ASUS P10S-E/4L (Intel® C236), 32G RAM ECC.
ZFS, RAID Z2, 8 disks.
Error " device: ATA error" start only if used iSCSI connection and then error continue fill log until POWER CYCLE of MB.
Reset of system not help for remove error "device: ATA error", only after POWER CYCLE of MB can help to use normally system.
Must sector size by always be 512 bytes for iscsi vol ?
Scrub on zpool ok.
when start: zpool scrub
have diag message some times: interrupt storm detect on "irq265:"; throttling interrupt source
ATA Status Error only if used iSCSI connection.:
SMART of DISK
Detect that when on remote system I start use attached iSCSI disk for write
On FreeNAS system have start messaging about error disk (device: ATA error count increased ...)
but cable checked, reattached, and errors on differ disk can be.
If use SAMBA services, NOT HAVE any errors on disk.
S.M.A.R.T. status of all disks is OK.
Disks SATA, WD RED 2TB. Connected to MB ASUS P10S-E/4L (Intel® C236), 32G RAM ECC.
ZFS, RAID Z2, 8 disks.
Error " device: ATA error" start only if used iSCSI connection and then error continue fill log until POWER CYCLE of MB.
Reset of system not help for remove error "device: ATA error", only after POWER CYCLE of MB can help to use normally system.
Must sector size by always be 512 bytes for iscsi vol ?
Scrub on zpool ok.
when start: zpool scrub
have diag message some times: interrupt storm detect on "irq265:"; throttling interrupt source
Code:
vmstat -i interrupt total rate irq265: ahci0 11696109 10534 dmesg |grep ahci0 ahci0: <Intel Sunrise Point AHCI SATA controller> port 0xf050-0xf057,0xf040-0xf043,0xf020-0xf03f mem 0xde510000-0xde511fff,0xde51e000-0xde51e0ff,0xde51d000-0xde51d7ff at device 23.0 on pci0 ahci0: AHCI v1.31 with 8 6Gbps ports, Port Multiplier not supported ahcich0: <AHCI channel> at channel 0 on ahci0 ahcich1: <AHCI channel> at channel 1 on ahci0 ahcich2: <AHCI channel> at channel 2 on ahci0 ahcich3: <AHCI channel> at channel 3 on ahci0 ahcich4: <AHCI channel> at channel 4 on ahci0 ahcich5: <AHCI channel> at channel 5 on ahci0 ahcich6: <AHCI channel> at channel 6 on ahci0 ahcich7: <AHCI channel> at channel 7 on ahci0
ATA Status Error only if used iSCSI connection.:
Code:
Jan 2 21:33:40 nas (ada5:ahcich5:0:0:0): Retrying command Jan 2 21:33:43 nas (ada7:ahcich7:0:0:0): WRITE_FPDMA_QUEUED. ACB: 61 0d d8 42 6a 40 78 00 00 00 00 00 Jan 2 21:33:43 nas (ada7:ahcich7:0:0:0): CAM status: ATA Status Error Jan 2 21:33:43 nas (ada7:ahcich7:0:0:0): ATA status: 41 (DRDY ERR), error: 10 (IDNF ) Jan 2 21:33:43 nas (ada7:ahcich7:0:0:0): RES: 41 10 d8 42 6a 00 78 00 00 00 00 Jan 2 21:33:43 nas (ada7:ahcich7:0:0:0): Retrying command Jan 2 21:33:43 nas (ada6:ahcich6:0:0:0): WRITE_FPDMA_QUEUED. ACB: 61 02 b1 97 6a 40 78 00 00 00 00 00 Jan 2 21:33:43 nas (ada6:ahcich6:0:0:0): CAM status: ATA Status Error Jan 2 21:33:43 nas (ada6:ahcich6:0:0:0): ATA status: 41 (DRDY ERR), error: 10 (IDNF ) Jan 2 21:33:43 nas (ada6:ahcich6:0:0:0): RES: 41 10 b1 97 6a 00 78 00 00 00 00 Jan 2 21:33:43 nas (ada6:ahcich6:0:0:0): Retrying command Jan 2 21:33:43 nas (ada4:ahcich4:0:0:0): WRITE_FPDMA_QUEUED. ACB: 61 01 66 98 6a 40 78 00 00 00 00 00 Jan 2 21:33:43 nas (ada4:ahcich4:0:0:0): CAM status: ATA Status Error Jan 2 21:33:43 nas (ada4:ahcich4:0:0:0): ATA status: 41 (DRDY ERR), error: 10 (IDNF ) Jan 2 21:33:43 nas (ada4:ahcich4:0:0:0): RES: 41 10 66 98 6a 00 78 00 00 00 00 Jan 2 21:33:43 nas (ada4:ahcich4:0:0:0): Retrying command Jan 2 21:33:43 nas (ada2:ahcich2:0:0:0): WRITE_FPDMA_QUEUED. ACB: 61 02 d1 93 69 40 78 00 00 00 00 00 Jan 2 21:33:43 nas (ada2:ahcich2:0:0:0): CAM status: ATA Status Error Jan 2 21:33:43 nas (ada2:ahcich2:0:0:0): ATA status: 41 (DRDY ERR), error: 10 (IDNF ) Jan 2 21:33:43 nas (ada2:ahcich2:0:0:0): RES: 41 10 d1 93 69 00 78 00 00 00 00 Jan 2 21:33:43 nas (ada2:ahcich2:0:0:0): Retrying command Jan 2 21:33:47 nas (ada5:ahcich5:0:0:0): WRITE_FPDMA_QUEUED. ACB: 61 01 20 59 6a 40 78 00 00 00 00 00 Jan 2 21:33:47 nas (ada5:ahcich5:0:0:0): CAM status: ATA Status Error Jan 2 21:33:47 nas (ada5:ahcich5:0:0:0): ATA status: 41 (DRDY ERR), error: 10 (IDNF ) Jan 2 21:33:47 nas (ada5:ahcich5:0:0:0): RES: 41 10 20 59 6a 00 78 00 00 00 00 Jan 2 21:33:47 nas (ada5:ahcich5:0:0:0): Retrying command
SMART of DISK
Code:
Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x002f 200 200 051 Pre-fail Always - 0 3 Spin_Up_Time 0x0027 184 184 021 Pre-fail Always - 3783 4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 87 5 Reallocated_Sector_Ct 0x0033 200 200 140 Pre-fail Always - 0 7 Seek_Error_Rate 0x002e 100 200 000 Old_age Always - 0 9 Power_On_Hours 0x0032 075 075 000 Old_age Always - 18511 10 Spin_Retry_Count 0x0032 100 100 000 Old_age Always - 0 11 Calibration_Retry_Count 0x0032 100 100 000 Old_age Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 87 16 Total_LBAs_Read 0x0022 000 200 000 Old_age Always - 48335351388 183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0 192 Power-Off_Retract_Count 0x0032 200 200 000 Old_age Always - 62 193 Load_Cycle_Count 0x0032 200 200 000 Old_age Always - 73 194 Temperature_Celsius 0x0022 126 111 000 Old_age Always - 21 196 Reallocated_Event_Count 0x0032 200 200 000 Old_age Always - 0 197 Current_Pending_Sector 0x0032 200 200 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0030 100 253 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0 200 Multi_Zone_Error_Rate 0x0008 100 253 000 Old_age Offline - 0
Last edited: