TeslasPigeon
Cadet
- Joined
- Jul 18, 2018
- Messages
- 6
I have recently put together a small NAS from the following components:
Motherboard: DFI-ITOX BE171 (AMD AMD RX-427BB SoC)
DRAM: 2x Micron 8GB PC3L-14900S 1866 MHz DDR3L SODIMM
SSD: Micron M600 MSATA 64GB
RAID controller: Startech PEXSAT34RH (Marvell 88SE9230)
HDD: 4x 3TB HGST (HUS724030ALE641)
I have installed Freenas on the SSD several times, and each time the installation completes without any errors. However, when it boots, it hangs at the following message, shortly after the LAN interfaces are initialized:
The system does not boot to the console setup menu, the system does not request a DHCP lease from the server, I cannot access the web GUI, and I cannot establish a serial connection through the com port. The motherboard has two LAN interfaces (Intel I210 and Realtek RTL8111EP), and the motherboard manual specifies that the RTL8111EP chipset supports Realtek DASH remote management, however the BIOS does not have an option to set a static IP for either LAN interface, only to disable DASH, which does nothing.
I am not familiar with IPMI, but my understanding is that it is a protocol used for remote management, although I am not sure how to utilize it (I assume it is related to the Realtek DASH remote management functionality?). Can anyone who is familiar with IPMI provide more insight into the situation, and a possible solution? I have exhausted my limited knowledge, and would appreciate any suggestions.
Motherboard: DFI-ITOX BE171 (AMD AMD RX-427BB SoC)
DRAM: 2x Micron 8GB PC3L-14900S 1866 MHz DDR3L SODIMM
SSD: Micron M600 MSATA 64GB
RAID controller: Startech PEXSAT34RH (Marvell 88SE9230)
HDD: 4x 3TB HGST (HUS724030ALE641)
I have installed Freenas on the SSD several times, and each time the installation completes without any errors. However, when it boots, it hangs at the following message, shortly after the LAN interfaces are initialized:
ipmi0: <IPMI System Interface> Port0xc000-0xc0ff mem
0xfe815000-0xfe815fff, 0xfe80400-0xfe807fff irq 39 at
device 0.3 on pci3
ipmi0: Using KSC interface
The system does not boot to the console setup menu, the system does not request a DHCP lease from the server, I cannot access the web GUI, and I cannot establish a serial connection through the com port. The motherboard has two LAN interfaces (Intel I210 and Realtek RTL8111EP), and the motherboard manual specifies that the RTL8111EP chipset supports Realtek DASH remote management, however the BIOS does not have an option to set a static IP for either LAN interface, only to disable DASH, which does nothing.
I am not familiar with IPMI, but my understanding is that it is a protocol used for remote management, although I am not sure how to utilize it (I assume it is related to the Realtek DASH remote management functionality?). Can anyone who is familiar with IPMI provide more insight into the situation, and a possible solution? I have exhausted my limited knowledge, and would appreciate any suggestions.