WebGUI only works after reboot

Joined
Oct 12, 2020
Messages
1
Hi all, relatively new to NAS in general. Installation went fine, I can still upload/download files to the server fine, and I can access the WebGUI. After leaving the server unattended for a while (a few hours/overnight), the next time I try access the WebGUI, the browser always times out and says I can't connect. Once I reboot the server, I can access the WebGUI again for a while, but then the same problem occurs. Any way to fix this?
 

Tigersharke

BOfH in User's clothing
Administrator
Moderator
Joined
May 18, 2016
Messages
893
Others will likely know more or have different suggestions including diagnostic output to track any issue. Without knowing more, such as your hardware details, configuration, I can only guess at a few things.
Could there be hibernate/suspend or sleep mode involved? Any sort of network setup which would limit access? Does DNS or some other necessary network service fail or timeout?

Please include your hardware information as noted in the forum guidelines in your next post.
 

pschatz100

Guru
Joined
Mar 30, 2014
Messages
1,184
If the system was built on a gaming motherboard, it is very possible that it is a power management option in the bios. Turn off power management.

As @Tigersharke commented, it is not possible to trouble shoot a problem without information.

Good luck.
 
Top