Hi there,
this is my second post, i posted the same in the german Part here.
I have an old computer rebuilt as Nas, each with 3 panels with UFS.
Yesterday it came to the worst case scenario and 2 of the volumes began. Why is a mystery to me.
Volume 2 (3x2 TB) has been marked as critical, the one plate gives up the ghost. So far, everything still in the open field.
However, Volume 1 was at the same time (also 3x2TB) marked as Unknown, in the boot process as Destroyed.
Stupidly, Freenas then took a HDD from Volume 1 to Volume 2 of Rebuild, as these were displayed as a new built-in drives.
How can I retrieve the data from Volume 1? Hope I have not made errors since I have posted the volume in the GUI.
Today the Volume 2 was finished with Rebuild, first everything was ok, but after a few hours the Volume 2 was degraded again, but there was nothing to do for the NAS.
To top it all the worse abound, I am not familiar with Unix commands.
Am grateful for any help
greeting
Harald
translated with google.
this is my second post, i posted the same in the german Part here.
I have an old computer rebuilt as Nas, each with 3 panels with UFS.
Yesterday it came to the worst case scenario and 2 of the volumes began. Why is a mystery to me.
Volume 2 (3x2 TB) has been marked as critical, the one plate gives up the ghost. So far, everything still in the open field.
However, Volume 1 was at the same time (also 3x2TB) marked as Unknown, in the boot process as Destroyed.
Stupidly, Freenas then took a HDD from Volume 1 to Volume 2 of Rebuild, as these were displayed as a new built-in drives.
How can I retrieve the data from Volume 1? Hope I have not made errors since I have posted the volume in the GUI.
Today the Volume 2 was finished with Rebuild, first everything was ok, but after a few hours the Volume 2 was degraded again, but there was nothing to do for the NAS.
To top it all the worse abound, I am not familiar with Unix commands.
Am grateful for any help
greeting
Harald
translated with google.