gilljr
Cadet
- Joined
- Oct 18, 2021
- Messages
- 5
Hardware
SAS2008 Controller (IT) Mode
Kingston A400 SSD (new)
Dell R610
I have used FreeNAS for many years including on the controller that I have moved to this server. Here is what I see.
The drive and controller show in the bios/post. When the installer boots, (legacy or UEFI) it shows the drive as 'da0' but when I select the install/upgrade option, there are zero drives to install on. I have flashed the card to the latest greatest firmware it can accept along with the boot rom for legacy and UEFI.
Any ideas on how to get the new SSD visible for installation. I am confused on what would make it visible to the installer as it loads but not allow it to populate in the install option. I believe the installer is the 12 U6 version.
Gilbert
SAS2008 Controller (IT) Mode
Kingston A400 SSD (new)
Dell R610
I have used FreeNAS for many years including on the controller that I have moved to this server. Here is what I see.
The drive and controller show in the bios/post. When the installer boots, (legacy or UEFI) it shows the drive as 'da0' but when I select the install/upgrade option, there are zero drives to install on. I have flashed the card to the latest greatest firmware it can accept along with the boot rom for legacy and UEFI.
Any ideas on how to get the new SSD visible for installation. I am confused on what would make it visible to the installer as it loads but not allow it to populate in the install option. I believe the installer is the 12 U6 version.
Gilbert