mistermanko
Guru
- Joined
- Jan 27, 2020
- Messages
- 577
Hi there,
I'm so far unsuccessfully attempting to crossflash a DELL PERC H310 card to IT-mode.
I've read and strictly followed the very well written guide over there: https://www.ixsystems.com/community...-lsi-9211-9300-9305-9311-hba-and-variants.54/
To run down my problem:
megarec -writesbr 0
megarec -cleanflash 0
(all successful)
Reboot
lsi-p5-sas2flash -o -f 6GBPSAS.FW
(successful)
lsi-p5-sas2flash -o -f 2118it.bin
(does not finish)
either stops with error "Failed to validate MfgPage2"
or with error "Cannot flash IT firmware over IR firmware"
I've also tried the sas2hax version, I tried a different sbr with megarec according to this guide, which is also mentioned in the newcomers guide down below: https://marcan.st/2016/05/crossflashing-the-fujitsu-d2607/
I tried different packages, the one in the newcomers guide, the one from here: https://techmattr.wordpress.com/201...-flashing-to-it-mode-dell-perc-h200-and-h310/
I tried sas2flash -e flag 6 or 7 both finish successful, but will not change the failures while flashing.
I'm really can't get my head around this. Any help would be appreciated!
I'm so far unsuccessfully attempting to crossflash a DELL PERC H310 card to IT-mode.
I've read and strictly followed the very well written guide over there: https://www.ixsystems.com/community...-lsi-9211-9300-9305-9311-hba-and-variants.54/
To run down my problem:
megarec -writesbr 0
megarec -cleanflash 0
(all successful)
Reboot
lsi-p5-sas2flash -o -f 6GBPSAS.FW
(successful)
lsi-p5-sas2flash -o -f 2118it.bin
(does not finish)
either stops with error "Failed to validate MfgPage2"
or with error "Cannot flash IT firmware over IR firmware"
I've also tried the sas2hax version, I tried a different sbr with megarec according to this guide, which is also mentioned in the newcomers guide down below: https://marcan.st/2016/05/crossflashing-the-fujitsu-d2607/
I tried different packages, the one in the newcomers guide, the one from here: https://techmattr.wordpress.com/201...-flashing-to-it-mode-dell-perc-h200-and-h310/
I tried sas2flash -e flag 6 or 7 both finish successful, but will not change the failures while flashing.
I'm really can't get my head around this. Any help would be appreciated!
Last edited: