Resilver after every reboot and errors on another drive

Status
Not open for further replies.

dclevy1

Dabbler
Joined
Jun 11, 2016
Messages
18
So guys I really need some help I am a super noob and I was replacing some drives on my machine that are bad. After replacing a drive that died I noticed that another drive has read errors on it. So basically after resilvering the drive the whole pool is still degraded. And after every reboot the drive resilver itself. So my question is after replacing the drive with errors on it as well will this fix my issues.

Sent from my SM-N910P using Tapatalk
 

JackShine

Dabbler
Joined
Nov 13, 2014
Messages
27
ZFS BSD uses serial numbers to identify HDDs, u may have disconnected the wrong HDD.
 

dclevy1

Dabbler
Joined
Jun 11, 2016
Messages
18
ZFS BSD uses serial numbers to identify HDDs, u may have disconnected the wrong HDD.
Well I don't think I did because the drive that I replace was dead so it was only showing 3 drives now I have 4. So how do I solve the issue with the drive resilvering every time I turned it on. I'm scared to replace the other job I'm having issues with if I don't get this resolved

Sent from my SM-N910P using Tapatalk
 

nojohnny101

Wizard
Joined
Dec 3, 2015
Messages
1,477
Please post output of zfs status in code tags.
 
Last edited by a moderator:
Status
Not open for further replies.
Top