Hi all
I seldom write or ask for help but this time its maybe a big issue for me. So I had a faulty disk, ONE and out of I dont know why, shut down the system pulled it out and replaced it with a new one. After I put in the new one, starte NAS and replaced the faulty disk. After 8hours I checked and my nas was not accessible anymore over web. So I checked with my i/o port and saw that it crashed. Still can access command line but zpool status shows ALL disks are degraded now. So
I restarted the nas and after about 15mins its in the same status where web isnt accessible anymore. So I thought put in the disk you pulled out where it was and plugin
the extra on a different port, but also the same problem after about 10mins.
So I have no clue now what todo and just hope with help I can save my data as I have no Backup. I use the onboard Raid controller and an extra SATA controller which also might have made the problem accure but thats not what I want to discuss. I really would like that it runs again and my data is back. Have to say that this setup runs now for about 5 years with no problem at all.
My Setup is_
Supermicro X10SLM-F (LGA 1150, Intel C224, mATX)
Kingston ValueRAM ECC-Reg (1 x 16GB, DDR3L-1600 (PC3-12800), DIMM 240 pin)
actual HD setup 8x3TB, right now 8x3TB and one 4TB as it was replacement
8 new 4TB HDs are on the way as I wanted to enlarge my RaidZ2
FreeBSD 12.2 Release P9 amd64
I seldom write or ask for help but this time its maybe a big issue for me. So I had a faulty disk, ONE and out of I dont know why, shut down the system pulled it out and replaced it with a new one. After I put in the new one, starte NAS and replaced the faulty disk. After 8hours I checked and my nas was not accessible anymore over web. So I checked with my i/o port and saw that it crashed. Still can access command line but zpool status shows ALL disks are degraded now. So
I restarted the nas and after about 15mins its in the same status where web isnt accessible anymore. So I thought put in the disk you pulled out where it was and plugin
the extra on a different port, but also the same problem after about 10mins.
So I have no clue now what todo and just hope with help I can save my data as I have no Backup. I use the onboard Raid controller and an extra SATA controller which also might have made the problem accure but thats not what I want to discuss. I really would like that it runs again and my data is back. Have to say that this setup runs now for about 5 years with no problem at all.
My Setup is_
Supermicro X10SLM-F (LGA 1150, Intel C224, mATX)
Kingston ValueRAM ECC-Reg (1 x 16GB, DDR3L-1600 (PC3-12800), DIMM 240 pin)
actual HD setup 8x3TB, right now 8x3TB and one 4TB as it was replacement
8 new 4TB HDs are on the way as I wanted to enlarge my RaidZ2
FreeBSD 12.2 Release P9 amd64