Hi guys, I recently installed FreeNAS on XenServer and am having issues getting FreeNAS to start when my LSI 9300-8i is passed through. I get the error found below:
This is preceeded by many of the following messages before finally kicking in:
I can see that it finds and identifies all the drives attached to the card it just stays at the above message thereafter. If I disable the passthrough I can boot normally. Anyone have any ideas what can cause this? Am I missing a tunable? I've tried many versions of the firmware for my LSI card (P9-P12) and the error has appeared on all 4.
Code:
run_interrupt_driven_hooks: still waiting after 60 seconds for xpt_config
This is preceeded by many of the following messages before finally kicking in:
Code:
mpr0: Warning: io_cmds_active is out of sync - resynching to 0
I can see that it finds and identifies all the drives attached to the card it just stays at the above message thereafter. If I disable the passthrough I can boot normally. Anyone have any ideas what can cause this? Am I missing a tunable? I've tried many versions of the firmware for my LSI card (P9-P12) and the error has appeared on all 4.
Last edited: