New here, have problems with iscsi LUN that don't show up when using D-link 10Gb switch DXS-1100-10T

[Mats Larsson]

Here is a short description of my problem.
I have a working environment with 2 xenserver 7.0, 2 tp-link 1GB switches, 1 freenas and a qnap.
I want to get rid of my qnap ang go for 10GB in 2 Freenas.
I bought new intel 10 GB NIC ( X540T2) .
I added the new NIC:s in xenserver, connected them to my old 1 GB switch from TP-Link (TL-SG2216) and it works fine.
Now my new switch from D-link arrives and my problem starts.
I configure the switches and when i try to create new SR in xencenter i can scan my target host and see my iscsi target in xencenter, but the LUN don't show up.
If i then connect this to my old TP-link switches, it works fina again.
The question is: What am i doing wrong in the D-link switches ?

 

[dlavigne]

Were you able to figure this out?

 

[Mats Larsson]

Hi dlavigne
No...
I have a case at D-Link right now. But that is a slow lane.
Do you got any suggestions ?
I'm not that deep into iScsi. But there are likely some difference between showing targets and LUN:s that D-Link hasn't thought of.

 

[dlavigne]

Sorry, no suggestions. Let us know if you get a resolution from D-Link.

 

[Mats Larsson]

D-Link support was not able to help me.
I sent back the switches where i bought them and bought a Netgear ProSAFE XS708T 10 GB instead.
There was no problems to set it up and i am up and running now.