Hey all.
I recently bought a new server and installed the latest version of TrueNAS.
Installation went smoothly. When I tried to set fixed ip and set vlan and lan,
everything stopped working. The only way to get started is to reset the network settings.
I have a Supermicros server with 8 network ports (4 ports 1Gb and 4 ports 10Gb).
When it comes to router, switch 1Gb and switch 10 GB everything is Unifi equipment.
I am looking for this solution:
1 port 1Gb should be used for menage.
3 port 10Gb use for link aggregation, iscsi and smb storage.
I prefer that they are not on the same network. Then I wonder how should I set the NAS.
Should I run link aggregation, should I run VLAN or LAN?
It should be good if there is a good guide on how to set everything.
Personally, I think TrueNA's guides suck. I need examples.
Before I uppdated to TrueNAS 12.
www.dropbox.com
with kind regards
Njanja
I recently bought a new server and installed the latest version of TrueNAS.
Installation went smoothly. When I tried to set fixed ip and set vlan and lan,
everything stopped working. The only way to get started is to reset the network settings.
I have a Supermicros server with 8 network ports (4 ports 1Gb and 4 ports 10Gb).
When it comes to router, switch 1Gb and switch 10 GB everything is Unifi equipment.
I am looking for this solution:
1 port 1Gb should be used for menage.
3 port 10Gb use for link aggregation, iscsi and smb storage.
I prefer that they are not on the same network. Then I wonder how should I set the NAS.
Should I run link aggregation, should I run VLAN or LAN?
It should be good if there is a good guide on how to set everything.
Personally, I think TrueNA's guides suck. I need examples.
Before I uppdated to TrueNAS 12.
Dropbox
with kind regards
Njanja
Last edited: