Installed Corral from scratch, moved data and now need to downgrade...

[papaja]

As Corral is being halted I am wondering how to move to 9.10?

I do not need VMs and Dockers, only want data in pool preserved.

 

[Ericloewe]

There's am FAQ in the resources section.

 

[Kevin Horton]

There's am FAQ in the resources section.

To be clear, Eric means the Resources list found from the link at the top of the page, not the Resources forum, which is a completely different thing. I'm mentioning this because my first inclination was to look in the Resources forum, and I found nothing there on moving from Corral to 9.10.

 

[jefri.misawar]

I were in the same situation as you. I re-installed 9.10 and imported the volume under storage section. No issue so far.


Sent from my iPad using Tapatalk

 

[papaja]

Thank you guys.

 

[markymark832]

I were in the same situation as you. I re-installed 9.10 and imported the volume under storage section. No issue so far.

I am in the same situation, vanilla corral install, moved all my data across into new smb shares.
Because i am running it all virtualized (esxi) can i just pass through the HBA controller to a 9.10 instance and then import the volumes?
Are there any issues with the ways corral formatted the array? Or the eay the permissions on the shares are setup etc?

Thanks Mark

 

[papaja]

I can confirm, that after installing Corral, I installed 9.10 and imported volume without any issues.

I cannot comment on your specific scenario.