Hello everyone
got FreeNAS-11.3-U2 fresh installed on a HP Proliant ML310 gen8, quad core Xeon, 32GB ECC ram, everything seems to work fine.
I have ad Eaton 5P 850 UPS with network card, but I can't figure out how to setup it into FreeNas.
I just managed to get temporary ups protection by connecting it with the USB cable.
My ups ip address is 192.168.0.230 (like 230 volt, hihi), but I can't set it up properly.
Apr 13 15:01:37 freenas upsmon[17119]: UPS [Eaton_5P_850@localhost:161]: connect failed: Connection failure: Connection refused
I am missing something... In my mind it should connect to 192.168.0.230, not to localhost.
Or are there config files that need to be manually edited for this to work?
Any help appreciated, documentation is very vague on that subject, and mainly refers to version 9 of FreeNas
got FreeNAS-11.3-U2 fresh installed on a HP Proliant ML310 gen8, quad core Xeon, 32GB ECC ram, everything seems to work fine.
I have ad Eaton 5P 850 UPS with network card, but I can't figure out how to setup it into FreeNas.
I just managed to get temporary ups protection by connecting it with the USB cable.
My ups ip address is 192.168.0.230 (like 230 volt, hihi), but I can't set it up properly.
Apr 13 15:01:37 freenas upsmon[17119]: UPS [Eaton_5P_850@localhost:161]: connect failed: Connection failure: Connection refused
I am missing something... In my mind it should connect to 192.168.0.230, not to localhost.
Or are there config files that need to be manually edited for this to work?
Any help appreciated, documentation is very vague on that subject, and mainly refers to version 9 of FreeNas