mofosachem
Dabbler
- Joined
- Jun 11, 2019
- Messages
- 11
hello thanks for reading.. I just started using freenas... I really like it, did some research on my issue and have come up short. - I have plex running in a jail ( i manually created the jail following a write up)... i didnt use the plug-in because i kept getting disconnected when i wanted to static map the ip. I have the freenas on .200 and the plex server on .201 with the default port.
I have three waps that are static mapped - i live in a concrete block structure in FL. The walls are thick and each room has a wap the model is tplink WA801ND v3, firmware is updated. I never have an issue. When freenas boots up and gets going, after a while i notice the waps vanish from the router listing table and they wont come back on till i reboot the wap hardware. this does not happen when the freenas server is in the off state. if i static map my laptop it will connect to the wap allow me to log in and reboot.
any thoughts on this would be helpful - i am considering getting more advanced waps.
thanks for the time
I have three waps that are static mapped - i live in a concrete block structure in FL. The walls are thick and each room has a wap the model is tplink WA801ND v3, firmware is updated. I never have an issue. When freenas boots up and gets going, after a while i notice the waps vanish from the router listing table and they wont come back on till i reboot the wap hardware. this does not happen when the freenas server is in the off state. if i static map my laptop it will connect to the wap allow me to log in and reboot.
any thoughts on this would be helpful - i am considering getting more advanced waps.
thanks for the time