Using legacy Supermicro server MB, 8GB RAM, 2 identical 4TB and 2 identical 500GB drives and an SSD 128G boot drive. Install went fine from CD. Under Storage - Disks all 4 drives show but when creating Pool only the 2 4TB show as available. Went ahead and created my pool on those, installed the Plex plugin no problem. Decided to just pull the 500G's but when I did my pool is gone!!! Put them back and pool reappears??? Since I can't seem to remove the the 500G's w/o losing 3 days populating the 4TB pool again how can I create a 2nd pool if they don't show???
-
Important Announcement for the TrueNAS Community.
The TrueNAS Community has now been moved. This forum will now become READ-ONLY for historical purposes. Please feel free to join us on the new TrueNAS Community Forums
4 disks detected in storage but only 2 shown when creating pool.
- Thread starter dbredes
- Start date
- Joined
- Nov 25, 2013
- Messages
- 7,776
Are there partitions with data, e.g. a previous Windows installation on these disks? If they show in
camcontrol devlist, you could wipe all partitions with gpart - they should show up afterwards.gpart reports drive busy.
- Joined
- Nov 25, 2013
- Messages
- 7,776
Please post the command you entered and its output.
Similar threads
