Hi guys, I was asked to take a look at a clients FreeNAS implementation and I ran into a few questions that the documentation didn't seem to discuss in detail. First off let me say I recognize 9.10 is quite an old build and yes we are in discussions with the client as to if they want to...

THE PROBLEM: I had a perfectly running volume for 3+ years that may be lost due to Sata drives being introduced to a brand new Supermicro SAS3 multipath, dual expander backplane environment. Any assistance that can be offered would be greatly appreciated. OLD SERVER: FreeNAS-11.1-U6 Norco 4224...

Hello, i have an DS4243 with two IOM6 modules installed. The diskshelf is connected to an LSI 9300-8e where i today upgraded the firmware to 16.00.01.00 via DOS. My second IOM6 module arrived today too but i can't get multipathing up and running. The camcontrol devlist just shows the 24 disks...

Running: FreeNAS-9.10.2-U2 (e1497f2) I had 2 drives failed over the long weekend. I put in new drives, ran /usr/local/bin/midclt call notifier.multipath_sync. It returned "null". When I go to replace either failed disk I do not get multipath drives, only da. Any advice? Here is my zpool...

Hi all I want to make sure that I have iSCSI setup correctly with multipath between my FreeNAS and 2 ESXi servers. First the FreeNAS server: The FreeNAS server has a dual port 10GbE card each port is on a different subnet/VLAN, the iSCSI portal is linked to both 10GbE ports, there is one iSCSI...

First, here is the setup I am using: Dell PE R410 FreeNAS 9.10.2-U1 2x Xeon e5520 Quad Core CPUs 12GB ECC RAM 4x 2TB Seagate Constellation ES drives in Raid Z1 1x 16GB Sandisk Cruzer as Boot drive DELL PERC 6/IR (Flashed to LSI IT Firmware) Dual Broadcom 1GB NICS Primary Interface -...

I am using a iXsystems Certified FreeNAS device. One of the most common annoyances I have run into is when trying to use a disk that was once used in another FreeNAS box. Of course whenever I do a Google search on what to do I run into the typical stuff that you see all over this forum: Give...

We're spinning up a server with the following: Dell R730xd, 16x 3.5 Drive Bay model - 12x front backplane, 4x mid backplane 14x 4TB NLSAS 256GB RAM 2x 10Core 2620 v3 FreeNAS-9.10.1-U4 Right now, we have a LSI 9300-8i plugged in, both SAS ports plugging into the front backplane. Everything...

Running Freenas 9.3-STABLE-201601181840 on iX-systems 24 bay filer. I just add 11 new drives to the 13 drives I had originally purchased with the machine. I'm trying to extend the original pool and I'm getting some odd behavior in the Volume Manager. Here is the original configuration...