dashtesla
Explorer
- Joined
- Mar 8, 2019
- Messages
- 75
Found a small issue with my FreeNAS 11.3, fresh install.
SMART won't start, I looked up online some people said i should disable any drives that do not support it, however doesn't seem to be the case since 11.2 that wasn't an issue running on the exact same enviroment/hardware.
The boot drive is a Hyper-V virtual drive, and I thought maybe why not just try to disable and reboot the entire system but that didn't work, all the other drives show up as it should and you get their serial numbers and everything else in every other way is fine, the pool is healthy no warnings of any kind I only noticed that because I went to the Services page and noticed that smart was set to start at boot but wasn't running and then i tried to start manually and it didn't work.
I checked the log and:
configuration file /usr/local/etc/smartd.conf parsed but has no entries
As usual any help is appreciated, if this is some kind of a bug let me know anything I can check on my system and I will post here.
SMART won't start, I looked up online some people said i should disable any drives that do not support it, however doesn't seem to be the case since 11.2 that wasn't an issue running on the exact same enviroment/hardware.
The boot drive is a Hyper-V virtual drive, and I thought maybe why not just try to disable and reboot the entire system but that didn't work, all the other drives show up as it should and you get their serial numbers and everything else in every other way is fine, the pool is healthy no warnings of any kind I only noticed that because I went to the Services page and noticed that smart was set to start at boot but wasn't running and then i tried to start manually and it didn't work.
I checked the log and:
configuration file /usr/local/etc/smartd.conf parsed but has no entries
As usual any help is appreciated, if this is some kind of a bug let me know anything I can check on my system and I will post here.