I have configured the network using Lagg. The network card is Gigabit link speed.
The network lagg0 speed alway stops at 1Gbps.
Please give me an advice :)
my cisco switch config:
#show running-config
interface Port-channel4
description FreeNas_LAGG_Group
switchport access vlan 18
switchport mode access
!
interface GigabitEthernet1/0/1
description FreeNas_LAGG
switchport access vlan 18
switchport mode access
spanning-tree portfast edge
channel-protocol lacp
channel-group 4 mode active
!
interface GigabitEthernet1/0/2
description FreeNas_LAGG
switchport access vlan 18
switchport mode access
spanning-tree portfast edge
channel-protocol lacp
channel-group 4 mode active
!
#show etherchannel summary
4 Po4(SU) LACP Gi1/0/1(P) Gi1/0/2(P)
#show interfaces port-channel 4
Port-channel4 is up, line protocol is up (connected)
Hardware is EtherChannel, address is
Description: FreeNas_LAGG_Group
MTU 1500 bytes, BW 2000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
Members in this channel: Gi1/0/1 Gi1/0/2
The network lagg0 speed alway stops at 1Gbps.
Please give me an advice :)
my cisco switch config:
#show running-config
interface Port-channel4
description FreeNas_LAGG_Group
switchport access vlan 18
switchport mode access
!
interface GigabitEthernet1/0/1
description FreeNas_LAGG
switchport access vlan 18
switchport mode access
spanning-tree portfast edge
channel-protocol lacp
channel-group 4 mode active
!
interface GigabitEthernet1/0/2
description FreeNas_LAGG
switchport access vlan 18
switchport mode access
spanning-tree portfast edge
channel-protocol lacp
channel-group 4 mode active
!
#show etherchannel summary
4 Po4(SU) LACP Gi1/0/1(P) Gi1/0/2(P)
#show interfaces port-channel 4
Port-channel4 is up, line protocol is up (connected)
Hardware is EtherChannel, address is
Description: FreeNas_LAGG_Group
MTU 1500 bytes, BW 2000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
Members in this channel: Gi1/0/1 Gi1/0/2