shnurov
Explorer
- Joined
- Jul 22, 2015
- Messages
- 74
To my surprise this morning coming into the studio and trying to open a project - server disconnected! :(
System concerned: the c2750d4i with 32gb ram + lsi card.
Tried logging in the console - no luck, IPMI - no luck.
Upon entering the server room - I discovered that it's off and when I press the start button the fans spin up to 100%, then 15s later set in at 55% as configured in the BIOS -upon which everything just shuts down within a minute - no IPMI connection, no FreeNAS console. At this point - if I press the power button again, I don't get anything - I have to turn off/on the PSU to be able to start up again. I tried changing PSU's - no luck there.
All this time the little green LED's on the board are 'on', that's odd because usually the IPMI one is 'flashing' when operation is normal.
I did receive some alarms about the CMOS battery dying - well I changed that. No luck.
Took out all the 'extra' stuff: UPS USB, LSI card, fans, 3 sticks of ram. Still nothing.
I have my home backup server - with a C2550D4I board in it - will try to swap the boards to see if that's the issue...
Any ideas?
System concerned: the c2750d4i with 32gb ram + lsi card.
Tried logging in the console - no luck, IPMI - no luck.
Upon entering the server room - I discovered that it's off and when I press the start button the fans spin up to 100%, then 15s later set in at 55% as configured in the BIOS -upon which everything just shuts down within a minute - no IPMI connection, no FreeNAS console. At this point - if I press the power button again, I don't get anything - I have to turn off/on the PSU to be able to start up again. I tried changing PSU's - no luck there.
All this time the little green LED's on the board are 'on', that's odd because usually the IPMI one is 'flashing' when operation is normal.
I did receive some alarms about the CMOS battery dying - well I changed that. No luck.
Took out all the 'extra' stuff: UPS USB, LSI card, fans, 3 sticks of ram. Still nothing.
I have my home backup server - with a C2550D4I board in it - will try to swap the boards to see if that's the issue...
Any ideas?
Last edited by a moderator: