Successfully flashed M1015 to IT mode. Can't detect in FreeNAS?

[axsuul]

On FreeNAS 9.10

I flashed my IBM ServeRAID M1015 SAS/SATA controller to IT mode and version 20.00.07.00 following these instructions: http://www.penlug.org/foswiki/bin/view/Main/FreeNasHardwareInfoIbmM1015

I verified within the UEFI shell that it has been successfully flashed by running sas2flash -listall. Then I rebooted into FreeNAS but my hard drives were still not detected. Opening up a terminal within FreeNAS, I ran the same command sas2flash -listall which returns:

Code:

No LSI SAS adapters found! Limited Command Set Available!
ERROR: Command Not allowed without an adapter!
ERROR: Couldn't Create Command -listall
Exiting Program.

Any suggestions as to why it's not being detected within FreeNAS? Thanks

 

[Chris Moore]

Without knowing what you saw when you did listall in the UEFI, it is hard to say. You might try flashing the card again using the instructions on the forum.

Detailed newcomers' guide to crossflashing LSI 9211 HBA and variants
https://forums.freenas.org/index.ph...o-crossflashing-lsi-9211-hba-and-variants.54/