Bret Whittacre
Cadet
- Joined
- Aug 31, 2015
- Messages
- 5
I ran the upgrade that was on the interface for FreeNAS. I made a serious mistake, and am hoping that someone can help me with my issues.
First, I have three drives in the system.
ada0 = 279 gigs
ada1 = 3.7 TB
ada2 = 3.7 TB
I had them set up so that ada0 was the system drive, and ada1 and ada2 where part of a zpool that would give me almost 8 TB.
After reboot, the only drive that show as available in the volumes GUI is ada2. I was looking around to see where ada1 went, and it looks like it somehow was attached to the boot. If I look at system -> boot -> Status It shows that there are two drives there ada0 and ada1 and that they are mirrored. This is not what I had before the upgrade.
Also, if I look at the volume that is there (media) under volume status, it shows it as a striped volume as ada2p2
So my question is this. How can I get ada1 back into the disk group so that I can see the data that was on the drive? I would really like to have it back.
Thanks in advance for any help that you may offer!
First, I have three drives in the system.
ada0 = 279 gigs
ada1 = 3.7 TB
ada2 = 3.7 TB
I had them set up so that ada0 was the system drive, and ada1 and ada2 where part of a zpool that would give me almost 8 TB.
After reboot, the only drive that show as available in the volumes GUI is ada2. I was looking around to see where ada1 went, and it looks like it somehow was attached to the boot. If I look at system -> boot -> Status It shows that there are two drives there ada0 and ada1 and that they are mirrored. This is not what I had before the upgrade.
Also, if I look at the volume that is there (media) under volume status, it shows it as a striped volume as ada2p2
So my question is this. How can I get ada1 back into the disk group so that I can see the data that was on the drive? I would really like to have it back.
Thanks in advance for any help that you may offer!