SOLVED - Tailscale IPv4 issue

[lucv]

So I have been trying to set-up Tailscale on my TrueNAS Scale server so I can access the server from remote networks (Im looking for SMB access mostly).

I am convinced that the issue lies in the incorrect IP address under the route setting for Tailscale in TrueNAS, see below:

So my TrueNAS's static IP is 192.168.1.66 , which is the IP I tried to input into the Tailscale setting under ROUTE so: 192.168.1.66/24
However, if I set the route to 192.168.1.66/24 the Tailscale would hand on DEPLOYING.

The only way I found to get it RUNNING was to advertise the 192.168.1.0/24 route as you can see in my screenshot of my settings.

So the 192.168.1.0/24 is RUNNING and connected to my Tailscale on my computer, however I cannot access it remotely:

My thought process is that the IP under route setting in TrueNAS for Tailscale is clearly incorrect so Tailscale can't properly establish a connection when on a remote network. However, if I input the correct static IP of my server then the app never RUNS and stays DEPLOYING.


Any help would be greatly appreciated.

 

[lucv]

The way I solved my particular issue was by enabling the ''HOST NETWORK'' in the settings, also follow this guide its great!:

How-To | TrueCharts

This is a quick how-to or setup-guide to use Tailscale using on your TrueNAS box.

truecharts.org