Serial ports are not listed in the WebUI (system->Advanced), the drop down shows just ---
From the shell:
root@filer[~]# ls -l /dev/cua*
crw-rw---- 1 uucp dialer 0x47 May 31 17:16 /dev/cuau0
crw-rw---- 1 uucp dialer 0x48 May 31 17:16 /dev/cuau0.init
crw-rw---- 1 uucp dialer 0x49 May 31 17:16 /dev/cuau0.lock
crw-rw---- 1 uucp dialer 0x4d May 31 17:16 /dev/cuau1
crw-rw---- 1 uucp dialer 0x4e May 31 17:16 /dev/cuau1.init
crw-rw---- 1 uucp dialer 0x4f May 31 17:16 /dev/cuau1.lock
root@filer[~]# grep -E '^(sio|uart)[0-9]' < /var/run/dmesg.boot
uart0: <16550 or compatible> port 0x3f8-0x3ff irq 4 flags 0x10 on acpi0
uart1: <16550 or compatible> port 0x2f8-0x2ff irq 3 on acpi0
uart1: console (115200,n,8,1)
The port should actually be configured for 9600 baud (that's what we have on the serial port server).
Ideas?
From the shell:
root@filer[~]# ls -l /dev/cua*
crw-rw---- 1 uucp dialer 0x47 May 31 17:16 /dev/cuau0
crw-rw---- 1 uucp dialer 0x48 May 31 17:16 /dev/cuau0.init
crw-rw---- 1 uucp dialer 0x49 May 31 17:16 /dev/cuau0.lock
crw-rw---- 1 uucp dialer 0x4d May 31 17:16 /dev/cuau1
crw-rw---- 1 uucp dialer 0x4e May 31 17:16 /dev/cuau1.init
crw-rw---- 1 uucp dialer 0x4f May 31 17:16 /dev/cuau1.lock
root@filer[~]# grep -E '^(sio|uart)[0-9]' < /var/run/dmesg.boot
uart0: <16550 or compatible> port 0x3f8-0x3ff irq 4 flags 0x10 on acpi0
uart1: <16550 or compatible> port 0x2f8-0x2ff irq 3 on acpi0
uart1: console (115200,n,8,1)
The port should actually be configured for 9600 baud (that's what we have on the serial port server).
Ideas?