OpenVPN Server TrueNAS 12 - Bridging TAP Device

[banquet]

I am setting up a OpenVPN server as a built in service on TrueNAS 12
I have all certificates set up and can connect to the server from outside the network. However I would like access to my entire internal network via the VPN. I can currently only access the TrueNAS server.
I believe this should be done through a bridge, where I would bridge the physical network adaptor and the virtual vpn tap interface. I cannot find where and how I would set this up.
Any advice would be appreciated.

 

[Lars Kluken]

I'm in the exact same situation. Did you figure it out?
BTW: My reason for doing TAP instead of TUN is that my router (deco x60) does not support static routes :(

 

[banquet]

No, I never figured it out. I ended up running an OpenVPN server on a VM and configured it from there.

 

[lopr]

see this thread to enable tap devices in a jail

SOLVED - openvpn issues in new jails after 11.1

i was trying to setup a iocage jail with openvpn in it but kept running into "Cannot allocate TUN/TAP dev dynamically" i tried with VNET on and off behaved the same. So i went back to the old ui and created a warden jail since i have done that before with openvpn and i actually still have a...

www.truenas.com