jeremyoha450
Dabbler
- Joined
- Mar 1, 2022
- Messages
- 19
Hi guys
i'm trying to get my asus xg-c100c card going
its listed in my pci dervices as
but i dont think is listed in my interfaces.
i tried ip link set dev enp3s0 up
when i do this it shows but i cant bring up, etc
what i need to do to get the card to work?
do i need to do install drivers?
please note i'm a noobie
i'm trying to get my asus xg-c100c card going
its listed in my pci dervices as
*-network
description: Ethernet interface
product: Aquantia Corp.
vendor: Aquantia Corp.
physical id: 0
bus info: pci@0000:03:00.0
logical name: enp3s0
version: 03
serial: 04:42:1a:57:d1:67
capacity: 10Gbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix bus_master cap_list rom ethernet physical tp 10bt-fd 100bt-fd 1000bt-fd 10000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=atlantic driverversion=5.10.93+truenas firmware=1.3.18 ip=192.168.10.1 latency=0 link=no multicast=yes port=twisted pair
resources: irq:16 memory:a0c00000-a0c7ffff memory:a0ca0000-a0ca0fff memory:a0800000-a0bfffff memory:a0c80000-a0c9ffff
but i dont think is listed in my interfaces.
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp3s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DEFAULT group default qlen 1000
link/ether 04:42:1a:57:d1:67 brd ff:ff:ff:ff:ff:ff
3: eno1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP mode DEFAULT group default qlen 1000
link/ether fc:34:97:a2:cd:65 brd ff:ff:ff:ff:ff:ff
altname enp0s31f6
i tried ip link set dev enp3s0 up
when i do this it shows but i cant bring up, etc
root@truenas[~]# sudo lshw -class network -short
H/W path Device Class Description
=========================================================
/0/100/1b/0 enp3s0 network Aquantia Corp.
/0/100/1f.6 eno1 network Ethernet Connection (14) I219-V
what i need to do to get the card to work?
do i need to do install drivers?
please note i'm a noobie