Haysden Smart
Dabbler
- Joined
- Sep 2, 2015
- Messages
- 20
I posted this in hardware support where it was suggested that it could be a bug, so here we go.
I have an IBM M1015 Flashed to IT mode V 20.00.04.00.
My FreeNas system returns an alarm saying Driver is 20.00.00.00 - Firmware is 20.00.04.00
I then get many errors returning "mps0: warning: io_cmds_active is out of sync - resyncing to 0"
After several of these errors the M1015 appears to re initiate and retrieves the drive ID's
Low and behold 2 minutes later it all happens over and over again.
My Data is safe and my FreeNAS is functioning, however this does delay data access from the drives. I believe it is if the drives have spun down and upon waking them up the card has some fort of malfunction.
I did not install the bios rom image when flashing, only the LSI Firmware.
Somebody PLEASE help.
FreeNas 9.3.1
Intel s2600cp2 motherboard
Intel Xeon e5-2603
32gb ecc registered
M1015 cross flashed
2x4x2tb raidz1 all WD Red
I have an IBM M1015 Flashed to IT mode V 20.00.04.00.
My FreeNas system returns an alarm saying Driver is 20.00.00.00 - Firmware is 20.00.04.00
I then get many errors returning "mps0: warning: io_cmds_active is out of sync - resyncing to 0"
After several of these errors the M1015 appears to re initiate and retrieves the drive ID's
Low and behold 2 minutes later it all happens over and over again.
My Data is safe and my FreeNAS is functioning, however this does delay data access from the drives. I believe it is if the drives have spun down and upon waking them up the card has some fort of malfunction.
I did not install the bios rom image when flashing, only the LSI Firmware.
Somebody PLEASE help.
FreeNas 9.3.1
Intel s2600cp2 motherboard
Intel Xeon e5-2603
32gb ecc registered
M1015 cross flashed
2x4x2tb raidz1 all WD Red