M1015 cross flashed firmware/driver issue version 20.00.04.00

Status
Not open for further replies.

Haysden Smart

Dabbler
Joined
Sep 2, 2015
Messages
20
I posted this in hardware support where it was suggested that it could be a bug, so here we go.

I have an IBM M1015 Flashed to IT mode V 20.00.04.00.
My FreeNas system returns an alarm saying Driver is 20.00.00.00 - Firmware is 20.00.04.00
I then get many errors returning "mps0: warning: io_cmds_active is out of sync - resyncing to 0"
After several of these errors the M1015 appears to re initiate and retrieves the drive ID's
Low and behold 2 minutes later it all happens over and over again.

My Data is safe and my FreeNAS is functioning, however this does delay data access from the drives. I believe it is if the drives have spun down and upon waking them up the card has some fort of malfunction.

I did not install the bios rom image when flashing, only the LSI Firmware.

Somebody PLEASE help.

FreeNas 9.3.1
Intel s2600cp2 motherboard
Intel Xeon e5-2603
32gb ecc registered
M1015 cross flashed
2x4x2tb raidz1 all WD Red
 
D

dlavigne

Guest
Note that this sub-forum is for discussing possible bugs. If you create an actual bug report at bugs.freenas.org, post the issue number here.
 

cyberjock

Inactive Account
Joined
Mar 25, 2012
Messages
19,525
Honestly, I'd just put a bug in at bugs.freenas.org. Nobody here is likely to be able to assist with this problem. :/
 
Status
Not open for further replies.
Top