Hello everybody,
I run a FreeNAS VM on an ESXi host version 6.7.0. (HPE Microserver GEN10 X3421 with 32GB RAM). The host boots from a USB stick. The VM runs on a NVMe SSD with 512GB. The Freenas VM is supported by 16GB Ram. Freenas uses a Raid 01 storage array of 4 x 4TB hard drives via the internal Marvel Raid Controller.
Is there a way that Freenas can output the S.M.A.R.T status of the hard drives?
I run a FreeNAS VM on an ESXi host version 6.7.0. (HPE Microserver GEN10 X3421 with 32GB RAM). The host boots from a USB stick. The VM runs on a NVMe SSD with 512GB. The Freenas VM is supported by 16GB Ram. Freenas uses a Raid 01 storage array of 4 x 4TB hard drives via the internal Marvel Raid Controller.
Is there a way that Freenas can output the S.M.A.R.T status of the hard drives?
