hello and cheers for this great piece of software! The forum is full of problems, so we though we could also share a success story: we have repurposed our linux-docker-running-bare-metal development server to a dedicated TrueNAS SCALE machine. We have read a lot of good explanations here and...

Dear friends, I have an idea to transform an HP Proliant DL380 G7 server with 16 2.5 "bays into a FreeNas to serve as storage for Proxmox hosts. The point is that my HP server has an onboard P440i controller (plus an extension for the 16 bays) that does not allow IT mode. So my idea is to...

Hi. I was reading all I found here about P822 card and I have few questions. E.g. @jgreco wrote: Is that something, what will never change? I mean if there is a chance, that ciss driver in 11.3 or newer systems will work better or will be replaced by another driver? Is such a card safe to be...

Hello everybody, I run a FreeNAS VM on an ESXi host version 6.7.0. (HPE Microserver GEN10 X3421 with 32GB RAM). The host boots from a USB stick. The VM runs on a NVMe SSD with 512GB. The Freenas VM is supported by 16GB Ram. Freenas uses a Raid 01 storage array of 4 x 4TB hard drives via the...

hi, i have been reading through past forum posts about the HPE Microserver Gen10 and after some initial problems people seemed to have success installing FreeNAS. i bought one and now i'm stuck at installation. hardware: HPE Gen10 3216 8GB RAM. BIOS version from august 2018, this is...

Hi, i will be install FreeNAS on ML 350 G5 with 8 SAS disk. Default in this machine is embedded RAID Controller e200i. What is the best Way for FreeNAS and ZFS? 1. Disable e200i - i don't know it is possible 2. if i can't disable maybe i can set every disk as single and then set RAIDZ in ZFS 3...

Hi I am installing FreeNAS-11.2-U3 on my HP DL380 G7 I am installing UEFI onto a USB and get this error. Thanks Luca

This is a guide to upgrade HPE iLO4 firmware to fix CVE-2017-12542. It is a remove vulnerability (details) so it is worth applying the security patch. iLO is a HPE Baseboard Management Controller (BMC) that equips most of HPE servers. If you have Gen8 or Gen9 HPE servers, (for example the very...

Hello, I have just bought an HP Microserver Gen10 to run FreeNAS on to replace my failing Netgear ReadyNAS Duo and probably once I have it working to replace my Qnap NAS as well. Before I bought the HP I read about the installation problems with the Gen10 here on this forum...