How to use Vlan on FreeNAS 11-u4?

[Kennyvb8]

ello there!
tried useing this "guide" https://forums.freenas.org/index.php?threads/how-to-set-separate-vlan-for-jail.54019/#post-374176
how ever it never reaches the router!?!
i have a edgerouter X where i made vlan aware vlan tag 250 and made switch0.250 vlan, then created a dhcp server in the router to the vlan
i have it working on my guest network so the config works! but can't get the freenas use different vlans for different jails!?!?

 

[Mihalich]

You can use different vlans for different services, if it possible for you.

 

[Kennyvb8]

You can use different vlans for different services, if it possible for you.

huh?!!? as i linked, someone has done it before, but useing that guide makes me haveing no connection to the router and outside world. hence why i made this post. coul dyou ellaborate what you mean ?

 

[Mihalich]

Add a VLAN, configure it in the tab "interfaces", later in the service, you can specify the address on which to listen to the selected service. The port on the switch must be in trunk mode.
Sorry, I don't understand that you can't configure at what stage.

 

[Kennyvb8]

Add a VLAN, configure it in the tab "interfaces", later in the service, you can specify the address on which to listen to the selected service. The port on the switch must be in trunk mode.
Sorry, I don't understand that you can't configure at what stage.

Done and done!
the problem is how to make the jail use vlan, and make it successfully connect to the router/outside world
when ever i make a vlan in the tab "interfaces" it takes 1 ip adress, correct? even that i can't see been leased/static in my router.. and therefore when i try following that guide on how to enable the vlan in jails the jails can't connect anywhere at all

 

[Mihalich]

In the settings interface your VLAN is it possible to specify a gateway? If not, then you need to write static routes for each VLAN.

 

[Kennyvb8]

In the settings interface your VLAN is it possible to specify a gateway? If not, then you need to write static routes for each VLAN.

Erhm. In FreeNAS 11-u4 No, this is not possible.
But there is a static routes tab next to interfaces.
But how to use?

 

[Mihalich]

Your vlan 250 has a network (for example: 192.168.250.0/24) and a gateway (192.168.250.1)
The route will be like this:
Destination network: 192.168.250.0/24
Gateway: 192.168.250.1
Description: VLAN250 (it is optional)

 

[Kennyvb8]

Your vlan 250 has a network (for example: 192.168.250.0/24) and a gateway (192.168.250.1)
The route will be like this:
Destination network: 192.168.250.0/24
Gateway: 192.168.250.1
Description: VLAN250 (it is optional)

done!
i figured out that i can't have VIMAGE enabled in jails ?!? when i uncheck it, do the echo "250" > iface into the .jail.meta/iface it works now!
what is VIMAGE anyway ?

 

[Mihalich]

I don't know, some crap for virtualization.