Viking8344
Cadet
- Joined
- Mar 30, 2024
- Messages
- 1
Hello, I am learning how to install truenas core by following the various tutorials but I am encountering a problem which has probably already occurred to some of you in the past.
My config
- intel i5
- 8 GB mem
- 500 GB SSD
- 4TB ironwolf HDD
At first, I installed TN on the HDD, then I bought an SSD on which I installed TN again. When I start on the SSD and go to the dashboard, storage section, disks >
the ada0 SSD and the ada1 HDD are recognized.
In the Pool manager section but when I want to create a pool in stipe mode for the HDD but I cannot do it because it does not appear.
- how to make the HDD appear?
- how to reformat my ada1 directly from the command line?
Thank you for your feedback
My config
- intel i5
- 8 GB mem
- 500 GB SSD
- 4TB ironwolf HDD
At first, I installed TN on the HDD, then I bought an SSD on which I installed TN again. When I start on the SSD and go to the dashboard, storage section, disks >
the ada0 SSD and the ada1 HDD are recognized.
In the Pool manager section but when I want to create a pool in stipe mode for the HDD but I cannot do it because it does not appear.
- how to make the HDD appear?
- how to reformat my ada1 directly from the command line?
Thank you for your feedback