SOLVED FreeNAS 9.1 on HP Proliant Microserver Gen8 MicroSD card

[ser_rhaegar]

To boot FN on the MS Gen8, do the following:

1. Turn on AHCI mode for the onboard SATA controller in the BIOS (this is not the default setting)
2. Use a USB thumb drive on the internal USB port

 

[avoien]

To boot FN on the MS Gen8, do the following:

1. Turn on AHCI mode for the onboard SATA controller in the BIOS (this is not the default setting)
2. Use a USB thumb drive on the internal USB port

I have already turn on AHCI Mode .
Even I have no any disk connect to onboard miniSAS, because , I plug M1015 Card on PCI-E slot#1 .
but, I still got some error about what I said before...

so poor ,....

 

[ser_rhaegar]

You're ignoring step 2.

If you actually are using a USB drive, how did you install FN on it? What method?

 

[avoien]

actually , I plug a 16Gb USB thumbs on the internal USB Port .

1.I use iLO4 and power on
2.mount LiveCD iso file
3.after loading opensolaris.ko .and take a while ...

umass0: <HP Virtual Media CDDVD ROM, class 0/0, rev 2.00/11.00, addr 2> on
usbus6
umass0: SCSI over Bulk-Only; quirks = 0x4101
umass0:2:0:-1: Attached to scbus2
(probe0:umass-sim0:0:0:0): INQUIRY. CDB: 12 00 00 00 24 00
(probe0:umass-sim0:0:0:0): CAM status: CCB request completed with an
error
(probe0:umass-sim0:0:0:0): Retrying command
(probe0:umass-sim0:0:0:0): INQUIRY. CDB: 12 00 00 00 24 00
(probe0:umass-sim0:0:0:0): CAM status: CCB request completed with an
error

over and over .....

 

[ser_rhaegar]

Is this while booting off of the installer ISO or off of the USB drive after a successful install?