StarkJohan
Explorer
- Joined
- Mar 27, 2015
- Messages
- 62
I'm on FN11-RC4. Creating a VM from the GUI and adding disk, VNC and CDROM seems to work fine. This allows me to get the VM to a RUNNING state, connect over VNC (with high image quality) and start the OS installation of ubuntu server 16.04.
However, when activating a NIC device for a VM it refuses to go from STOPPED to RUNNING mode. This is true for both e1000 and VirtIO. I see no error output in /var/log/messages. Just these two lines when attempting to start the VM. As it is not RUNNING I cannot connect over VNC. Am I missing something obvious?
I haven't found any other threads discussing this particular issue but feel free to point me in the right direction if that is the case.
However, when activating a NIC device for a VM it refuses to go from STOPPED to RUNNING mode. This is true for both e1000 and VirtIO. I see no error output in /var/log/messages. Just these two lines when attempting to start the VM. As it is not RUNNING I cannot connect over VNC. Am I missing something obvious?
Code:
Jun 7 17:43:49 Superservern tap28: Ethernet address: 00:bd:8f:64:2e:1c Jun 7 17:43:49 Superservern kernel: tap28: promiscuous mode enabled
I haven't found any other threads discussing this particular issue but feel free to point me in the right direction if that is the case.
