kirkdickinson
Contributor
- Joined
- Jun 29, 2015
- Messages
- 174
Ok, I am doing my second FreeNAS box. The last one had the SuperMicro X10SL7-F mobo, and this one has X10SLL-F mobo. I was going through the same procedures that I used to set up the other one and when I got to the part about Ctrl-C to see the LSI controller, that didn't come up. I don't think this board has the LSI controller to flash to IT mode. It dosn't have the SAS ports liek the SL7, so that would make sense.
My question is: Do I have to do anything to this bios wise before I install FreeNAS?
Do I assume that the regular SATA ports can be properly accessed by FreeNAS as is?
Thanks,
Kirk
My question is: Do I have to do anything to this bios wise before I install FreeNAS?
Do I assume that the regular SATA ports can be properly accessed by FreeNAS as is?
Thanks,
Kirk