Error during installation of vitualbox client

Status
Not open for further replies.

ric

Contributor
Joined
Dec 22, 2013
Messages
180
This error only happening when I tried installing a second vm client on to the virtualbox host.

First attempt installing the first client was installed successfully without any issues.

And also every time this problem occur, my Freenas system network interface connection will completely disconnected saying "Now configured interfaces were found", and I had to manually reboot my freenas system to get it back to normal operation again.

virtualbox_error_during_installation_FREENAS.png
 
Last edited:

Robert Trevellyan

Pony Wrangler
Joined
May 16, 2014
Messages
3,778
How are you assigning IPs to the clients? Looks like you're getting a clash with your server.
 

ric

Contributor
Joined
Dec 22, 2013
Messages
180
It happened during or before the actual installation of the OS component and files (somewhere at the initial process of installing the OS).

Not sure if this related to assigning the resources of the vm guest or what, but I don't think that's the case because normally if there's anything misconfigured at that time when creating or allocating resources of the vm guest, it doesn't go the installation process.
 
Last edited:

Robert Trevellyan

Pony Wrangler
Joined
May 16, 2014
Messages
3,778
Are the network settings for the first and second client the same? Are you using NAT, or bridged, or some other configuration?
 

ric

Contributor
Joined
Dec 22, 2013
Messages
180
Both clients are in Bridge connection. So, I tried turning off the other client and then proceed to the installation of the second client that went successful. Network settings on both clients are fine.

I suspect maybe not enough RAM that the Host UTO during installation process.

I ordered additional RAM, and lets see what happens.
 
Last edited:

ric

Contributor
Joined
Dec 22, 2013
Messages
180
I finally received the RAMs from yesterday, and tried to install on my freenas system. Just to test I created another VM while other vm client is running, and finally it works! Just to make sure I added more VM clients into the Host, and Viola! It works again.

BUT, the problem is all my installed plugins are gone. I tied reinstalling them by going to Plugins tab> Available, but here's what I got "No entry has been found"

On the other hand Jails are remained intact, and nothing affected there.

Troubleshooting that I did:

Rebooted system (twice).
Reconfigured Network Freenas interface (all values are the same as before)

I verified my Network> "Global Configuration":

Hostname:
freenas
Domain: dcs01.local

IPv4 Default Gateway:
192.168.1.1

Nameserver 1: 192.168.1.1
Nameserver 2: 192.168.1.20 (Domain Controller)
Nameserver 3: 8.8.8.8
 
Status
Not open for further replies.
Top