smishsmorshen
Cadet
- Joined
- Jun 12, 2016
- Messages
- 5
Hello there,
So my drives were limited by 2.2tb because of the onboard controller I was using. I have since installed an 9207-8i and now my 4tb drives (which previously only were recognized as 2.2tb) now show correctly as 4tb.
However I'm not sure on how to get the volume expanded to take advantage of the new space. I checked and confirmed that autoexpand is enabled on the pool.
Ideas?
Thank you in advance!
So my drives were limited by 2.2tb because of the onboard controller I was using. I have since installed an 9207-8i and now my 4tb drives (which previously only were recognized as 2.2tb) now show correctly as 4tb.
However I'm not sure on how to get the volume expanded to take advantage of the new space. I checked and confirmed that autoexpand is enabled on the pool.
Ideas?
Thank you in advance!
Last edited: