I try to install the latest 2 versions in a Supermicro server (SYS-6036ST-6LR) with no success. Both USB key and disk method fail.
There are two 1G and two 10G Ethernet ports on board. The second board of the box hosts a Proxmox server.
The 1G ports work under the "igb" driver (eth0 - eth1). I also manage to make a lacp lagg out of them. But only under dhcp. When i enter static data everything goes wrong. Gui freezes, and cli stops identifying ports. Must re-install.
The 10G ports are assigned to "ix" driver! (eth2 - eth3). Proxmox and Openfiler installs the "ixgbe" driver, and the FreeBSD H/W pages also shows the "ixgbe" driver.
If i configure the 10G ports first, they seem to work, and the lagg between them too. But the lagg is dead and cannot communicate with Proxmox. Openfiler in the same board works fine, lagg or not.
If i try to activate the 1G ports after that, also everything freezes... The Cli sees only the first lagg, no other ports. Some times i cannot even reboot.
So in my understanding, the 10 G ports are installed with the wrong driver and freeze everything...
Are there more recent drivers, or what? Will this be solved in next RC maybe?
There are two 1G and two 10G Ethernet ports on board. The second board of the box hosts a Proxmox server.
The 1G ports work under the "igb" driver (eth0 - eth1). I also manage to make a lacp lagg out of them. But only under dhcp. When i enter static data everything goes wrong. Gui freezes, and cli stops identifying ports. Must re-install.
The 10G ports are assigned to "ix" driver! (eth2 - eth3). Proxmox and Openfiler installs the "ixgbe" driver, and the FreeBSD H/W pages also shows the "ixgbe" driver.
If i configure the 10G ports first, they seem to work, and the lagg between them too. But the lagg is dead and cannot communicate with Proxmox. Openfiler in the same board works fine, lagg or not.
If i try to activate the 1G ports after that, also everything freezes... The Cli sees only the first lagg, no other ports. Some times i cannot even reboot.
So in my understanding, the 10 G ports are installed with the wrong driver and freeze everything...
Are there more recent drivers, or what? Will this be solved in next RC maybe?