kneitzel
Cadet
- Joined
- Sep 20, 2017
- Messages
- 5
Hi,
I am quite new to FreeNAS and just did an installation of FreeNAS on my system:
Mac Mini with i7 / 16GB RAM, internal 60GB SSD / 500GB SSD and external case (usb3) with currently 3 disks (2* 1TB, 1* 8TB).
When I installed FreeNAS, the main install was done on the 60GB SSD and I added the 500GB SSD inside the Volume "System" which is used for jails by default.
So I have the following disks inside my system:
1) ada0 - 500GB SSD -> /mnt/System
2) ada1 - 60 GB SSD -> FreeNAS install
3) da0 - 1 TB -> /mnt/Data
4) da1 - 1 TB -> /mnt/Data
5) da2 - 8TB -> not used - just added to the system.
When I go to "Storage" and click "Show Disks", I only see:
ada0
da2
Before I added the 8TB disk, it showed me:
ada0
da1
So da0 was missing from the start and now da0 and da1 are not shown.
Is there anything that I am doing wrong? I would expect that all my disks are shown.
The system is running fine, the zpools are up and running as expected. (e.g. zpool list, zpool status commands on command line) So I am really just wondering about the data shown inside the web gui.
Thank you in advance for your assistance.
With kind regards,
Konrad
I am quite new to FreeNAS and just did an installation of FreeNAS on my system:
Mac Mini with i7 / 16GB RAM, internal 60GB SSD / 500GB SSD and external case (usb3) with currently 3 disks (2* 1TB, 1* 8TB).
When I installed FreeNAS, the main install was done on the 60GB SSD and I added the 500GB SSD inside the Volume "System" which is used for jails by default.
So I have the following disks inside my system:
1) ada0 - 500GB SSD -> /mnt/System
2) ada1 - 60 GB SSD -> FreeNAS install
3) da0 - 1 TB -> /mnt/Data
4) da1 - 1 TB -> /mnt/Data
5) da2 - 8TB -> not used - just added to the system.
When I go to "Storage" and click "Show Disks", I only see:
ada0
da2
Before I added the 8TB disk, it showed me:
ada0
da1
So da0 was missing from the start and now da0 and da1 are not shown.
Is there anything that I am doing wrong? I would expect that all my disks are shown.
The system is running fine, the zpools are up and running as expected. (e.g. zpool list, zpool status commands on command line) So I am really just wondering about the data shown inside the web gui.
Thank you in advance for your assistance.
With kind regards,
Konrad