LIGISTX
Guru
- Joined
- Apr 12, 2015
- Messages
- 525
I am very knew to Freenas and Linux in general. I will be starting my build in the near future and just trying to learn up on stuff so I can hit the ground walking like a baby, not crawling lol.
Stupid jokes aside, I have been looking around the forum for SMART and Scrub related things and unless I missed something (I am sure I did since you guys are thorough) how do you actually go about setting SMART and Scrubs up? Is there anything that must be done in command line or through the webUI to actually set them up to work properly on the drives? Or is it just a on off slider in the webUI, set and forget and boom SMART is working?
And just to see if I am learning the lingo and understand what is happening correctly, SMART tests are on a drive by drive basis, but a scrub is across the entire pool? I did read the thread about hdd burn in, and I assume during burn in I don't want to be doing any of these tests correct? Just let the burn in do its thing after memtesting my RAM, then build my pool and enable these features and schedule them correct?
Stupid jokes aside, I have been looking around the forum for SMART and Scrub related things and unless I missed something (I am sure I did since you guys are thorough) how do you actually go about setting SMART and Scrubs up? Is there anything that must be done in command line or through the webUI to actually set them up to work properly on the drives? Or is it just a on off slider in the webUI, set and forget and boom SMART is working?
And just to see if I am learning the lingo and understand what is happening correctly, SMART tests are on a drive by drive basis, but a scrub is across the entire pool? I did read the thread about hdd burn in, and I assume during burn in I don't want to be doing any of these tests correct? Just let the burn in do its thing after memtesting my RAM, then build my pool and enable these features and schedule them correct?