f64897011
Cadet
- Joined
- Aug 20, 2013
- Messages
- 6
Hi there,
I'm using FreeNAS 9.2.1.5-release on a Supermicro chassis with 24 disks installed. When I used the "Manual Setup" wizard of WebGUI ZFS volume manager to create a 10 disks raidz2 * 2 volume it showed successfully created. But there's no volume entry on the GUI unless I refresh Chrome. Everything else is working fine (zpool status, etc). I've also tried "manual setup" of 9.2.1.4, 9.2.1.3, 9.2.1.2 they all failed to show the volume entry until I refresh the explorer. Anyone encountered the same problem or any help would be very appreciated. Hope this one can be fixed in the near 9.2.1.6 release.
I'm using FreeNAS 9.2.1.5-release on a Supermicro chassis with 24 disks installed. When I used the "Manual Setup" wizard of WebGUI ZFS volume manager to create a 10 disks raidz2 * 2 volume it showed successfully created. But there's no volume entry on the GUI unless I refresh Chrome. Everything else is working fine (zpool status, etc). I've also tried "manual setup" of 9.2.1.4, 9.2.1.3, 9.2.1.2 they all failed to show the volume entry until I refresh the explorer. Anyone encountered the same problem or any help would be very appreciated. Hope this one can be fixed in the near 9.2.1.6 release.