Version of Network UPS Tools?

[Patrick M. Hausen]

Hi all,

could someone already running the BETA please check which version of NUT is on board?

Code:

upscmd -h

should do the trick.

 

[PhilD13]

In Dragonfish-24.04-RC.1 the command returns

Network UPS Tools upscmd 2.8.0

which is the same returned in the current Cobia TrueNAS-SCALE-23.10.2

 

[Patrick M. Hausen]

That's the broken version. We need 2.8.1. I'll open a ticket.

Thanks!

 

[PhilD13]

That's probably why It wouldn't work at first on my recently updated Cobia system.

 

[PhilD13]

What issue did you find?

I actually don't think it was the Cobia system that had an issue though the service was turned off and not set for autostart, but I can't say that at this point not actually an error on my part during setup. On DragonfishRC which is running on VirtualBox as a VM it is also now working and providing charts. I just needed to configure the service first then enable it.

 

[Patrick M. Hausen]

2.8.0 does not read the UPS state from Cyberpower SNMP cards. 2.8.1 allegedly does.