Hi, appeal to the community because I did not find information in Google.
Recently installed FreeNAS 11.3-RELEASE-p5 I decided to connect the UPS.
I have an APC BackUPS es700. When I try to configure over GUI i have error "This field is required" , in system messages. If configure "ups.conf"
then it working, but until the first reboot, after which the config becomes empty.
Questions:
Why does not work configure in GUI?
If it’s impossible to configure in GUI, how to make the config not clear?
Thanks!
Recently installed FreeNAS 11.3-RELEASE-p5 I decided to connect the UPS.
I have an APC BackUPS es700. When I try to configure over GUI i have error "This field is required" , in system messages
Code:
freenas upsmon[1165]: UPS [ups@localhost:3493]: connect failed: Connection failure: Connection refused
Code:
[ups] driver = usbhid-ups port = auto desc = apc_es700
then it working, but until the first reboot, after which the config becomes empty.
Questions:
Why does not work configure in GUI?
If it’s impossible to configure in GUI, how to make the config not clear?
Thanks!
Last edited: