john-woods
Dabbler
- Joined
- Jul 22, 2012
- Messages
- 17
Hi everyone,
I recently had a drive fail on my RAID 5 array, running on FreeNAS 9.1.1. I followed the interactions in the manual and successfully replaced the drive to restore the RAID array. However the drive re-appeared in the Volume Status list, but with it's status as UNAVAIL. I have tried again, using the GUI, to Detach it but it doesn't work. I am given a notification that it has been detached but it just stays there. A second hard drive failed more recently, I replaced it in the same way and now I have the same problem again.
So basically I would like to know if there are any alternative ways to force these old volumes to be detached? I have attached a picture of my setup for reference.
Thanks,
John
I recently had a drive fail on my RAID 5 array, running on FreeNAS 9.1.1. I followed the interactions in the manual and successfully replaced the drive to restore the RAID array. However the drive re-appeared in the Volume Status list, but with it's status as UNAVAIL. I have tried again, using the GUI, to Detach it but it doesn't work. I am given a notification that it has been detached but it just stays there. A second hard drive failed more recently, I replaced it in the same way and now I have the same problem again.
So basically I would like to know if there are any alternative ways to force these old volumes to be detached? I have attached a picture of my setup for reference.
Thanks,
John