I am setting new a new server with FreeNAS 9.10. So far setup has been fine, except I am now running into a problem trying to assign multiple IP addresses to the Portal.
I am trying to configure an ISCSI target with MPIO, across 4 dedicated network ports.
I create a portal with the following properties:
Comment: temp storage
Discovery Auth Method: none
Dicovery Auth Group: none
Portal IP Address: <address 1>
Portal Port: 3260
As long as I limit it to just one address, it works fine.
But when I click "Add extra Portal IP", specify an additional address, and click ok, I get:
I tried tailing /var/log/messages and /var/log/debug.log, but nothing showed up.
I didn't run into this problem on a previous server running 9.3. I have tried this with the ISCSI service both on and off, and I'm now at a loss as to what to look for.
Has anyone else run into this issue?
I am trying to configure an ISCSI target with MPIO, across 4 dedicated network ports.
I create a portal with the following properties:
Comment: temp storage
Discovery Auth Method: none
Dicovery Auth Group: none
Portal IP Address: <address 1>
Portal Port: 3260
As long as I limit it to just one address, it works fine.
But when I click "Add extra Portal IP", specify an additional address, and click ok, I get:
- This field is required.
- This field is required.
I tried tailing /var/log/messages and /var/log/debug.log, but nothing showed up.
I didn't run into this problem on a previous server running 9.3. I have tried this with the ISCSI service both on and off, and I'm now at a loss as to what to look for.
Has anyone else run into this issue?