Storage Config - UFS or ZFS using Adaptec AAR2610SA Raid Controller
I'm not sure on how to add my current storage into FreeNas 8.3.0
I am running an Adaptec AAR2610SA Sata Raid Controller with 4x 1 TB drives. I have a Raid 10 array configured on the controller and FreeNAS sees this as a Single Disk. When i goto configure a new volume in FreeNAS should i use ZFS or UFS?
some clarity on the best way to configure this system would be very helpful
I do intend on adding another 4x drives attached to a second controller card that is exactly the same but possibly larger drives
advice is much appreciated
I'm not sure on how to add my current storage into FreeNas 8.3.0
I am running an Adaptec AAR2610SA Sata Raid Controller with 4x 1 TB drives. I have a Raid 10 array configured on the controller and FreeNAS sees this as a Single Disk. When i goto configure a new volume in FreeNAS should i use ZFS or UFS?
some clarity on the best way to configure this system would be very helpful
I do intend on adding another 4x drives attached to a second controller card that is exactly the same but possibly larger drives
advice is much appreciated