"Someone reset channel A" durning installation.

[RChadwick]

I'm extremely new to FreeNAS. I have a SuperMicro X5DPE-G2 Xeon MB, a 3Ware 9660 SATA controller, An IDE-CF adapter to install FreeNAS on CF, and a single SATA drive hooked up for test purposes. When I boot from a CD-ROM of FreeNAS 8.0.4 32-bit (after a bit of research, the CPUs seem to almost, but don't support 64 bit), after the menu, I eventually get :

ahd0: Someone reset channel A
ahd0: Someone reset channel A
ahd0: Someone reset channel A
ahd0: Someone reset channel A
ahd0: Someone reset channel A

I never get to the point where I have the option to install FreeNAS. I thought it might be because it wouldn't install to CF, so I put in a USB drive, with the same results. This MB has onboard SCSI, which I'm not using (And haven't figured out how to disable)

I've played with the BIOS settings a bit, but I'm pretty much out of ideas. Anyone know what might be going on?

Thanks!

 

[raulfg3]

ahd0 is the SCSI Disk, so you need to disable onboard SCSI, read your Board Manual, normally this board have a key conbination to access to BIOS of SCSI controller ( Crtl-A, F12, or something similar), once you enter on the onboard SCSI BIOS, you can disable it